| Option |
Explanation of option |
| 2 Vacuum suction circuit |
In addition to a standard product vacuum suction circuit, expansion is possible up to two circuits. |
| Air blow circuit |
In addition to a standard air blow circuit, expansion is possible up to two circuits. |
| Product chuck circuit(single/double acting) |
In addition to a standard product chuck circuit, expansion is possible up to two circuits. |
| Sprue cut circuit |
It is a circuit to cut a sprue by a nipper inside an end-of-arm tool. Combined use with "Gate cut inside end-of-arm tool inside" is not applicable. |
| Gate cut inside end-of-arm tool circuit |
It is a circuit to approach a nipper blade to a gate and then cut it inside an end-of-arm tool. Combined use with "Sprue cut circuit" is not applicable. |
| Reject circuit |
When the molding machine gives reject signal to the take-out robot, the defective product is released at a different position from that for good products. |
| End-of-arm tool quick changer |
An end-of-arm tool can be attached or detached quickly with this device. |
| Signal light / signal tower |
This indicates the status of the take-out robot. |
| External detection at ascent limit |
After the products are taken out, this detects whether or not there are any products left, using a limit switch at the ascent limit of the take-out robot. |
| Traverse end stanchion |
It is used when the traverse frame is extended or when very precise position accuracy for products release is required. |
| External nipper unit at traverse frame |
After products requiring gate cutting are taken out, gate cutting is done with nippers attached to the traverse limit. |
| Mutilingual display change function |
Displayed language on the controller can be changed from multilingual choices (Japanese, English, Chinese/ Japnanese, English, Korean/Japanese. English, Thai/ Japanese, English, Indonesian). |
