<<Explanation of the typical model name>>

J-HOP
HOME >> J-HOP

OutlineDimensionsOption List
J-HOP 650R-R, J-HOP 650R-L
J-HOP 650RX-R, J-HOP 650RX-L

Mold clamping force Mold clamping force 20 -100ton
Swing angle Swing angle 0- 180
(Selection from 0, 45, 90, 135 , 180)
Adjustable stroke Adjustable stroke
Adjustable chuck waiting position Adjustable chuck waiting position
Controller Controller GII-type controller
Click on the above mark displays an explanatory page.
J-HOP


Sprue picker for vertical molding machine
This robot is applicable for runner extraction out of small-size molding machine.

Compact design for space-saving
It offers enough horizontal moving distance, 1380mm maximum from mold center to sprue runner release point, even though the overall robot width is approximately half of the conventional model.
Stable high-speed operation with servo motor
Equipped with a servo-driven joint arm, it saves overhang floor space from a molding machine given to a take-out robot body. That enables crusher setting close to the rear-side of the molding machine. Additionally, it offers reduction of take-out cycle time.

   
 


Power voltage AC200V 2.25A (50/60Hz)
Control method Micro computer control
Working Pressure 0.5MPa
Maximum allowable pressure 0.8MPa

Model J-HOP 650R-R J-HOP 650R-L J-HOP 650RX-R J-HOP 650RX-L
Stroke
 Entry (mm) Stroke 680 / Release position 1380*1 (1680)*2
Descent (mm) 90
Swing Selection from 0, 45, 90, 135 , 180
Air consumption
liter(Normal)/cycle 		2.6
Maximum weigh capacity 1Kg
Robot weight 40Kg
*1 Standard --- rotating radius 350mm / *2 (vvv)dimension --- rotating radius 500mm
Up
Copyright (C) , 2003. Yushin Precision Equipment Co.,Ltd. All rights reserved.