<<Explanation of the typical model name>>
	SXA-10II		HOME >> SX-series

		SXA-10II Mold clamping force 5 - 15ton No. of servo axes 2 axes

	Stabilizes the quality of delicate products These days, much higher quality is required for delicate products such as connectors. Extraction of molded products after molding process determines the quality of such products. The SXA-10II interlocks with super small molding machines with which product take-out and installation of a take-out robot have been considered difficult. This robot allows you to raise the ratio of good products and achieve stable molding. Installed beside a molding machine   There is less vibration from a take-out robot to a molding machine because the robot is not installed onto the stationary platen of the molding machine.		User-friendly controller ''E-touch Lite'' SXA-10II is equipped with user-friendly controller "E-touch Lite" that has 7.5 inch colored LCD touch panel with quick response of picture conversion. Additionally, this controller has user-programming software "Lead Through Teaching" as a standard function.

Power voltage AC200V (50/60Hz) Driving method Digital servo motor (2 axes) Control method Micro computer Working pressure 0.49MPa(Gauge) Maximum allowable pressure 0.79MPa(Gauge)

Model SXA-10II Maximum Power Consumption AC200V 2.3A(Suck-up type blow with out) Traverse Stroke (mm) 400mm(standard),550mm(Extended Type) Kick Stroke (mm) 200mm(standard),300mm(Extended Type) Air consumption liter(Normal) / cycle 18.0 l(Normal)/cycle(Suction Ejector type) 9.0 l(Normal)/cycle(Suction blow type) 3.0 l(Normal)/cycle(adsorption type) Maximum payload (kg) Less than 1Kg

Copyright (C) , 2003. Yushin Precision Equipment Co.,Ltd. All rights reserved.